My old Mac has two type of structures to keep the heddle bars in place - a wonderful, strong, simple metal clip on some bars (didn't photo those) and on others an old paper fasterner (see photo).  Some of those old paper fasteners have worn out, so I bought new ones.  As could be expected, the new paper fasteners are crap.  Made out of really cheap metal, they aren't strong enough and bend or break with frequency.

So what have you all found that will keep your heddle bars from sliding off the harness frames?

Thanks!

heddle bar clip

Comments

ReedGuy

Could you get yourself some 1/8" brass rod at the hardware store and fashen yourself something?

I've used brass rod for the hinge on a wooden temple, for the bottom bars of shafts when tying up, for attaching wooden reels on a skein reel and for attaching wheels under a fly shuttle.

Depends on how big the hole is that it needs to go in. If it's around 1/8" you could make something like my shaft bar pins. If it's a 3/16" hole or a little bigger you could double it with an eye on the thumb end, then put a little crimp at 90 degrees on the ends pointing inward. Then open it up a little so there is a springy resistance. Pinch the two ends in the middle so the crimps pass through the holes to the end. Release, and locked in place because of the eye at one end and the crimps are  flared outward so the pin can't come out until pinched in the middle again.

Put a small bolt in a vise and use the curvature of it to make the eye. The shaft holes and the crimps on the end are a bit exaggerated.

The $1 buck solution that will last a lifetime. ;D

tommye scanlin

I simply tie with strong string, through the hole in the heddle holder and around the frame.  Works just fine.

Tommye

sequel (not verified)

You can tie by passing a long string through the upper heddle bar hole from front to back then down to the lower heddle bar hole from front to back and then tie the remaining ends together for a figure 8.

Dena (not verified)

I use small paper clips on mine, but...Macomber does sell replacement clips.

heatherbarrick (not verified)

zip ties are so cheap and come in small sizes. i would try to zip one tight and clip the tail so it doesnt impede the harness movement, at least to keep you weaving until you come up with a permenant solution.

jander14indoor (not verified)

I'm not too familiar with the Macomber so I don't know if there's enough room, but would a short machine screw with a locking nut work?

Jeff Anderson

Penn (not verified)

Cotter pins have a slim profile, are lightweight, easy to slip off yet secure, and won't prong your hands the way those paper fasteners do.  I hate those things.

Submitted by Anonymous (not verified) on