Hi Weavers! I have finally started my first rag rug on my 4 shaft counterbalance loom. I'm wondering if I should loosen the tension when I'm not weaving like I do with other projects or if I should leave it in its tightened state. 

Thanks!

Comments

steve104c (not verified)

I don't see a problem with loosening the tension a bit. I don't loosen my tension but I don't think it will mess up your rug in waiting........Steve.

sally orgren

You know, I never thought about this before!

I normally don't loosen the tension when I leave the loom, as I weave nearly every day. I also weave on a jack loom, so there is probably some benefit to loosening the warp since the warps are being pulled down slightly in the "rest" position.

I know for rug weaving, you are typically weaving under high tension, so that may change the equation. But if you are using linen warp, it has very little give, so it shouldn't make any difference.

On a counter balance loom, aren't your shafts equalized as they hang (so there should be no problem there?)

Why do you loosen the warp on other projects? And what are your typical warp materials? (It occurs to me a wool warp might stretch over time, and I have to admit, I don't weave with wool much.)

GREAT question, and I hope other more experienced weavers than I will weigh in, as I would like to hear their answers!

Sally

naturalfibres (not verified)

I do remember when I first learned to weave that one of my instructors said to loosen the tension when not weaving, so I did it at first, but then stopped and it didn't make any difference.  So now I don't bother to loosen the tension.

apw1970 (not verified)

I just leave the tension as is, regardless of the project.  That way, there isn't that first inch or two that looks different because the tension hasn't been adjusted exactly the way it was.

If I go away for a few days, though, I do lower the tension.  I weave just about every day, though.

Submitted by Anonymous (not verified) on