Hi all,

I've used metal and texsolv heddles on various looms and have rarely encountered fraying or shredding of warp yarns. However I'll soon start a new project with 8/2 Tencel, with 3 threads being threaded per metal heddle. I've read here that some people encounter fraying when using Tencel. I wonder if that's due to metal heddles? Would it behoove me to use Texsolv for this particular project?

Comments

Sara von Tresckow

New, polished metal heddles are not dangerous for your threads.

Old metal heddles, especially the twisted wire ones, can develop sharp edges and spots that catch threads. In the case of twisted wire, the lower portion of the eye where the wires twist can change over time and trap fine threads (had this happen on a very old museum loom).

If worried aboutyour tencel, you might try applying laundry starch to the warp to protect the yarn surface from abrasion.

laurafry

I don't believe that the metal heddles have a particular impact on Tencel fraying.  There are other issues that can cause a problem.  

Tencel likes a firm but not overly tight tension on the loom.  I've found that an very full bobbin can stress the selvedges and cause breakage.  Much better in my experience to wind them less full than fat.

Another issue that may or may not be appropriate to you - Tencel likes a humid environment much better than an arid one.

Try not to 'stress' the yarns by unweaving if at all possible.  Lay in a good angle of weft and beat once.  Repeated thumps of the beater can also over stress Tencel (or any 'fragile' yarn).

If you have a temple, try weaving with that.  It will help keep the warp threads parallel and prevent draw in.

cheers,

Laura

Weavin Steven

Thanks for the feedback. I do use a temple and an end-feed shuttle. Those should keep the fraying to a bare minimum. Plus the heddles are not the twisted-wire type.

laurafry

Sounds like you are ready to jump in, then.  :)

cheers,

Laura

mrdubyah (not verified)

As Sara says, inserted eye heddles are benign, but twisted wire heddles, especially old ones, are prone to thread trapping.  Flat steel heddles also definitely do cause wear on warp threads.  To minimize the potential for breakage, try to weave relatively short sections, only a few inches at a time, and advance the warp frequently.  Each time you advance, you pull the frayed section out of the heddles and put in a new, unworn section.  

Submitted by Weavin Steven on