I have done a lot of rigid heddle weaving and have finally been able to acquire a floor loom. It's an old LeClerc four-shaft 45" beauty and I'm so excited about it! I wove a tablecloth and napkins in tabby weave and they were beautiful. Now I'd like to branch out and use all four shafts. I have everything set up for some towels in waffle-weave and tied up the treadles, but when I tried to start weaving, I wasn't getting a decent shed on any thing that had more than one heddle tied to each treadle. What am I doing wrong? I've been going through my books, but just can't seem to find the info I need - so much of it is over my head at this point in my weaving! Can anyone help? Thanks!

Comments

ReedGuy

It may be the tie-up to the shafts. If there are lamms, they should equal the number of shafts and are tied centrally. And the horse at one end of a shaft is tied up so the horse on the other end will mirror it on the shafts. For instance on horse 1 (toward the outside) , one end is tied to shaft one the other end to shaft two. The horse on the far end has the outside end of the horse tied to one and the inside to two. And continue on with shafts 3 and 4 with the next set of horses. The lamms give weight to the shafts with gravity, the horses pull up on the shafts.

Submitted by MaryCatLover on